Published: 07 June 2019

Erratum: Multi-cutter turning process stability analysis

A. M. Gouskov1
M. A. Guskov2
Ding Dyk Tung3
G. Panovko4
1, 4Mechanical Engineering Research Institute of the Russian Academy of Sciences, Moscow, Russia
2PIMM Laboratory UMR 8006, ENSAM, CNRS, CNAM, Paris, France
3, 1, 4Applied Mechanics Department, Bauman Moscow State Technical University, Moscow, Russia
Corresponding Author:
A. M. Gouskov
Views 18
Reads 5
Downloads 1180

The description of the correction

There was an error in the author’s affiliation in the paper finally approved (after the acceptance) by the authors.

Incorrect affiliation:

1, 4Vibrations Laboratory, RAS Institute of Machine Science, St. Petersburg, Russia

Revised affiliation:

1, 4 Mechanical Engineering Research Institute of the Russian Academy of Sciences, Moscow, Russia

About this article

Received
Accepted
05 May 2019
Published
07 June 2019
Source