Abstract
This paper takes up the previous research paper on the considered topic and extends the proportional feedbacks of correction and compensation system by replacing them by PID controllers. The paper presents a part of research of the gyroscopic stabilizer and describes a gyroscopic stabilizer correction and compensation system. Consequently, identification of the effect of correction and compensation system parameters settings for the system behavior is described. Estimation of concrete compensation and correction settings is reported in this study
About this article
Received
July 29, 2010
Accepted
September 10, 2010
Published
September 30, 2010
Keywords
gyroscopic stabilizer
vibration-isolation
optimization
PID controller
Copyright © 2010 Vibroengineering
This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
