Output signal accuracy calibration of autocollimators

Brucas, D.; Giniotis, V.; Ingensand, H.

Journal of Vibroengineering

Browse Journal

Submit article

Published: 30 September 2009

Check for updates

Output signal accuracy calibration of autocollimators

D. Brucas¹

V. Giniotis²

H. Ingensand³

Cite the article

Downloads 0

About this article

Received

Accepted

Published

30 September 2009

This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Previous article in issue Previous

Research article

2021 11 05

Parameter identification of oscillations in power systems based on improved variational modal decomposition and HTLS-adaline method

Chunlu Wan, Kang Wang, Zhixiang Wu

Research article

2020 11 26

A system design method based on digital AGC photoelectric preamplifier gain adaptive control

Xuefeng Gu, Gaoquan Gu, Jing Zhang

Research article

2019 09 30

Error correction and uncertainty measurement of short-open-load calibration standards on a new concept of software defined instrumentation for microwave network analysis

M. Nazrin, S. J. Hashim, F. Z. Rokhani, B. M. Ali, Z. Yusoff

Research article

2017 03 31

System identification of force transducers for dynamic measurements using particle swarm optimization

Jianshan Lu

Output signal accuracy calibration of autocollimators

About this article

Related Articles