Abstract
Correlation between shape errors of the tool and ceramic work-pieces are presented in the paper. A new tool, on which different shape errors of convexity or concavity can be set, was used during experiments. Results from flat grinding, such as the shape errors, are presented and analyzed. Computational calculations concerning the local shape errors of the tool and the technological effects such as surface roughness and waviness parameters as well as the workpiece plane-parallelism are also presented.
About this article
Received
September 8, 2011
Accepted
May 14, 2012
Published
June 30, 2012
Keywords
flat grinding
shape errors
ceramics
Copyright © 2012 Vibroengineering
This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
