Vibroengineering PROCEDIA, Vol. 35

Fault diagnosis based on vibration signal analysis

Vibration diagnosis of turbomachinery coupled with induction motor Krishnareddy G, Venkatesham B, Ramireddy G

p. 1-6 PDF

Modal analysis and applications

Triple resonances involving two frequencies in the motor frequency conversion start phase Bai-Zhou Li, Hui-Min Wu, Lan-Rong Cai

p. 7-12 PDF

Vibration in transportation engineering

Control of the air suspension system of semi-trailer trucks to enhance the road friendliness Huaxiang Zhou, Xiaoyan Wu, Peiling Wang	p. 13-19 PDF
Effect of the mass-stiffness distribution of the vibratory roller cab on the ride quality in low-frequency region Huan Yuan, Zhiqiang Zhang, Aoran Yang, Hao Dong	p. 20-26 PDF

Biomechanics and biomedical engineering

Biped dynamic walker with alternate unpowered and partially powered steps in a gait cycle Krishna Prakash Yadav, Prasanth Kumar R

p. 27-32 PDF

Dynamics and oscillations in electrical and electronics engineering

Simulation of three-phase short circuit electromagnetic transient process of synchronous generator Hongtao Wang

p. 33-38 PDF

Materials and measurements in engineering

Fracture and damage model of composite ceramics Jinfeng Yu, Zhaogang Cheng, Xinhua Ni, Xiequan Liu, Da Xu	p. 39-45 PDF
A system design method based on digital AGC photoelectric preamplifier gain adaptive control Xuefeng Gu, Gaoquan Gu, Jing Zhang	p. 46-51 PDF

Mathematical models in engineering

Mathematical modeling of the solution to the problem of plate bending given various fastenings along the contour and various loads Serikbay Toibayev, Assemgul Uderbayeva, Zhanar Bidakhmet, Ayaulym Rakhmatulina, Algazy Zhauyt	p. 52-57 PDF
Numerical simulation of polygonal spiral curved pipe with abrasive flow machining based on large eddy simulation Weihong Zhao, Xiwei Dong, Ximing Hui, Qifei Peng, Junye Li, Chenri Zhang	p. 58-63 PDF
Editor's Pick Bending of a circular flexible plate taking into account the initial curvature G. U. Mamatova, А. K. Sugirbekova, N. M. Bekaulov	p. 64-69 PDF
Processing method of EMD endpoint effect based on SVRM extension Kai Chai, Shao-Wei Feng	p. 70-75 PDF
An improved method for EMD modal aliasing effect Shao-Wei Feng, Kai Chai	p. 76-81 PDF
Modeling and simulation on engraving process of projectile rotating band based on two-phase flow interior ballistic Zhen Wang, Liqun Wang, Guolai Yang	p. 82-87 PDF
Reliability analysis of railway freight car wheelset based on Birnbaunm-Saunders fatigue life distribution Yaxuan Zhang, Ziliang An, Mingxu Lu, Qingbiao Meng	p. 88-93 PDF
Optimal 5R parallel leg design for quadruped robot gait cycle Mangesh D. Ratolikar, Prasanth Kumar R	p. 94-98 PDF

System dynamics in manufacturing system modeling

Comparison of friction power loss between crankpin and crankshaft bearings on improving the engine power Nguyen Van Liem, Xiaoyan Guo, Renqiang Jiao

p. 99-104 PDF