Journal of Vibroengineering

Volume 16, Issue 3

May 15, 2014, Pages (1106-1618)

Research article

2014-05-15

Design considerations of a MEMS cantilever beam switch for pull-in under electrostatic force generated by means of vibrations

Serhat İkizoğlu, Ayşe Özgül Ertanır

p. 1106-1113

Research article

2014-05-15

Investigation on soft landing impact test of scale lunar lander model

Qing Lin, Zhiyu Kang, Jie Ren, Qilong Zhao, Hong Nie

p. 1114-1139

Research article

2014-05-15

Self-synchronization theory of a nonlinear vibration system driven by two exciters. Part 2: Numeric analysis and experimental verification

Li Ye, Li He, Wei Xiaopeng, Wen Bangchun

p. 1140-1150

Research article

2014-05-15

Hysteresis behavior of reinforced concrete bridge piers considering strength and stiffness degradation and pinching effect

Qiang Han, Huihui Dong, Xiuli Du, Dezhang Sun, Chao Huang

p. 1151-1161

Research article

2014-05-15

Seismic test and numerical verification of the scaled-down reinforced concrete containment vessel

Yu-Chih Chen, Wei-Ting Lin, Tung-Liang Chu, Yuan-Chieh Wu

p. 1162-1167

Research article

2014-05-15

Study on the extraction method of transverse open crack’s information

Yang Liu, Qin-Liang Li, Hong-Liang Yao, Bang-Chun Wen

p. 1168-1178

Research article

2014-05-15

Analytical solution for dynamic response of segment lining subjected to explosive loads

Yang Liu, Mingyang Wang, Derong Wang

p. 1179-1187

Research article

2014-05-15

The finite element modeling and stability prediction of high-speed spindle system dynamics with spindle-holder-tool joints

Bo Wang, Wei Sun, Kunpeng Xu, Junyong Zhang, Bangchun Wen

p. 1188-1199

Research article

2014-05-15

A bearing fault detection method based on compressive measurements of vibration signal

Xinpeng Zhang, Niaoqing Hu, Guojun Qin, Zhe Cheng, Hua Zhong

p. 1200-1211

Research article

2014-05-15

Validation of bucket wheel drive component model through vibration monitoring: a torque arm key study

Vesna Damnjanović, Predrag Jovančić

p. 1212-1218

Research article

2014-05-15

Modal parameters identification based on noise reduction for jacket type offshore platforms

Structural nonlinear vibration reliability analysis based on improved ant colony algorithm

Yancang Li, Chenguang Ban, Shujing Zhou, Qiuyue Cheng, Shuanghong Peng

p. 1231-1239

Research article

2014-05-15

Stochastic bifurcation characteristics of cantilevered piezoelectric energy harvester

Jia Xu, Ming-Yi Luan, Zhi-Wen Zhu, Kang-Kang Guo

p. 1240-1247

Research article

2014-05-15

Investigation of stresses during dynamic behavior of polymeric films used for Braille

I. Venytė, E. Kibirkštis, A. Voloshin, K. Ragulskis, P. Paškevičius, A. Sudintas, L. Ragulskis

p. 1248-1257

Research article

2014-05-15

Sensorless speed control of a vector controlled three-phase induction motor drive by using MRAS

Ali Saffet Altay, Mehmet Emin Tacer, Ahmet Faik Mergen

p. 1258-1267

Research article

2014-05-15

Peak cycle stress analysis of plain dent on pipeline based on FE calculation

Ying Wu, Wu Liu, Huawen Wu, Peng Zhang

p. 1268-1275

Research article

2014-05-15

Theoretical analysis on thermally induced vibration of tapered parallelogram plate with mixed boundary conditions

Anupam Khanna, Pratibha Arora

p. 1276-1283

Research article

2014-05-15

Dynamic stress response and fatigue life of cantilever beam under non-Gaussian base excitation

Junyong Tao, Hongwei Cheng

p. 1284-1296

Research article

2014-05-15

Relation between reduction of weighted impact sound pressure level and shape of small size specimen of floating floor construction

Vidmantas Dikavičius, Kęstutis Miškinis, Karolis Banionis, Edmundas Monstvilas

p. 1297-1305

Research article

2014-05-15

Antiseismic response research of horizontal residual heat removal pump in different seismic spectrum input directions

Xin Deng, Shouqi Yuan, Jianping Yuan, Qiaorui Si, Yalin Li, Yuwen Zhu

p. 1306-1317

Research article

2014-05-15

A novel semi-active suspension design based on decoupling skyhook control

Jialing Yao, Saied Taheri, Songmei Tian, Zhongnan Zhang, Liang Shen

p. 1318-1325

Research article

2014-05-15

Efficiency improvement of energy harvester at higher frequencies

Giedrius Janusas, Ieva Milasauskaite, Vytautas Ostasevicius, Rolanas Dauksevicius

p. 1326-1333

Research article

2014-05-15

Investigation of clamping force for a high-speed shaft with toolholder using contact element analysis

Shin-Yong Chen, I-Feng Lin

p. 1334-1342

Research article

2014-05-15

Investigation of tactile characteristics of the piezoelectric bimorph type actuators

R. Bansevičius, V. Jūrėnas, M. Gudauskis, A. Žvironas

p. 1343-1348

Research article

2014-05-15

Assessment of the vibroactivity level of SI engines in stationary and non-stationary operating conditions

Figlus Tomasz, Liščák Štefan

p. 1349-1359

Research article

2014-05-15

Proposing an optimal integral-based intensity measure for seismic collapse capacity assessment of structures under pulse-like near-fault ground motions

Masood Yakhchalian, Ahmad Nicknam, Gholamreza Ghodrati Amiri

p. 1360-1375

Research article

2014-05-15

Applying b-value variation to seismic hazard analysis using closed-form joint probability distribution

Ahmad Nicknam, Mostafa Khanzadi, Sasan Motaghed, Azad Yazdani

p. 1376-1386

Research article

2014-05-15

Bearing performance degradation assessment and prediction based on EMD and PCA-SOM

Chen Lu, Hang Yuan, Youning Tang

p. 1387-1396

Research article

2014-05-15

Investigation of air-coupled generation of asymmetric Lamb waves using rectangular phased arrays

Almantas Vilpišauskas, Rymantas Kažys

p. 1397-1404

Research article

2014-05-15

Development of large salient-pole synchronous machines by using fractional-slot concentrated windings

Tayfun Gundogdu, Guven Komurgoz

p. 1405-1415

Research article

2014-05-15

Reduction of axis acceleration of quarter car suspension using pneumatic actuator and active force control technique

P. Sathishkumar, J. Jancirani, John Dennie

p. 1416-1423

Research article

2014-05-15

An approach for tool health assessment using the Mahalanobis-Taguchi system based on WPT-AR

Chen Lu, Yujie Cheng, Zhipeng Wang, Jikun Bei

p. 1424-1433

Research article

2014-05-15

The defect detection in glass materials by using discrete wavelet packet transform and artificial neural network

An approach to performance assessment and fault diagnosis for hydraulic pumps

Bei Jikun, Lu Chen, Wang Zhipeng, Wang Zili

p. 1444-1454

Research article

2014-05-15

Deformation-compensated modeling of flexible material processing based on T-S fuzzy neural network and fuzzy clustering

Yaohua Deng, Sicheng Chen, Jiayuan Chen, Jiayi Wu, Qiaofen Zhang, Liming Wu, Hui Chen

p. 1455-1463

Research article

2014-05-15

Health assessment and fault diagnosis for centrifugal pumps using Softmax regression

Jian Ma, Chen Lu, Wenjin Zhang, Youning Tang

p. 1464-1474

Research article

2014-05-15

Influence of imbalance force angular position to vertical and horizontal rotors rolling bearings defects diagnostics

Artūras Tadžijevas, Vytautas Barzdaitis, Pranas Mažeika, Marius Vasylius

p. 1475-1482

Research article

2014-05-15

Flutter analysis for wing structure using finite element modeling with equivalent stiffness

Xing Ouyang, Xiongqing Yu, Yu Wang

p. 1483-1493

Research article

2014-05-15

A new nonlinear longitudinal vibration model of belt driving system applied in energy saving

Mingming Xing, Shimin Dong

p. 1494-1509

Research article

2014-05-15

Fracture toughness prediction of eutectic ceramic composite considering damage effect and transformation toughening

Xinhua Ni, Cheng Chen, Shuqin Zhang

p. 1510-1522

Research article

2014-05-15

Human activity recognition: classifier performance evaluation on multiple datasets

Pavel Dohnálek, Petr Gajdoš, Tomáš Peterek

p. 1523-1534

Research article

2014-05-15

Development of vibrating bracelet for the actuation of the blood circulation at capillaries

M. Venslauskas, V. Ostasevičius, V. Jūrėnas

p. 1535-1542

Research article

2014-05-15

Vibrations of a plate on a two-parameter foundation subjected to moving rectangular loads of varying velocities

Zheng Lu, Hailin Yao, Yongxiang Zhan, Zhi Hu

p. 1543-1554

Research article

2014-05-15

Simulation of the lateral oscillation of rope-guided conveyance based on fluid-structure interaction

Renyuan Wu, Zhencai Zhu, Guoan Chen, Guohua Cao, Wei Li

p. 1555-1563

Research article

2014-05-15

Identification of second-order kernels in aerodynamics

Yunhai Wang, Jinglong Han, Zhang Bin

p. 1564-1573

Research article

2014-05-15

A well-balanced unsplit finite volume model with geometric flexibility

Byunghyun Kim, Taehyung Kim, Jinho Kim, Kunyeon Han

p. 1574-1589

Research article

2014-05-15

Combination resonances of parametric vibration system of the field modulated magnetic gear

Xiuhong Hao, Xiaoming Yuan, Hongfei Zhang, Lijie Zhang

p. 1590-1601

Research article

2014-05-15

Application of Butterworth filter for fault diagnosis on journal bearing

T. Narendiranath Babu, T. Manvel Raj, T. Lakshmanan

p. 1602-1617

2014-05-15

JVE International Conferences 2014

p. 1618-1618